How do you refill a triple torch lighter?

How do you refill a triple torch lighter?

How to Refill?

1. Drain any remaining fuel before refilling.
2. Set flame adjuster to lowest before filling.
3. 3.To refill,hold unit upside down and firmly push the butane can nozzle into the filling valve.
4. Stop refilling when you see the fluid in the tank is full.
5. Wait at least 2 minutes after filling before using the lighter.

What do you refill a torch lighter?

Hold your lighter fully in an upside down position (this helps avoiding air entering the fuel tank when you go to fill). Shake your butane can and press the stem of the can directly onto the refill valve (while in a straight up-and-down position). Hold for about 5 seconds and release.

Why is my torch lighter not refilling?

Troubleshooting: If you are having problems with your lighter, make sure that: You are holding the lighter upside down while refilling. If you did not hold the lighter upside down, there will be air inside the butane tank. You will need to let the air out and try refilling again.

How do you unclog a torch lighter?

To clean a clog out of a propane torch, you will need to remove the nozzle and boil it in water. Once it’s thoroughly boiled, the residue in the torch should come out of its own accord. Take the nozzle out, let it dry, and then reattach it to your torch to complete your de-clogging.

Why won’t my Bernzomatic torch stay lit?

There could be a blockage in the valve. This could be caused by a piece of debris, or the valve could be frozen due to the endothermic reaction mentioned above. Clean or thaw the valve to fix. The valve on the tank it self could be blocked/frozen, but this is unlikely as you tried an alternate tank.

Can a butane torch explode?

As a highly flammable and pressurized gas, it’s possible that butane may explode if exposed to heat or used improperly.

How do you maintain a torch lighter?

4 Steps to to maintain your butane torch

1. Use quality butane. – Good butane will burn clean and keep the jets on the torch cleaner.
2. Purge torch of all butane and air before filling and refilling.
3. Don’t torch too close.
4. Use your torches.