How do you use Bluecol antifreeze?

How do you use Bluecol antifreeze?

Product Specifications

1. Whilst engine is cold, remove cap from radiator or expansion tank.
2. Check antifreeze level.
3. If necessary, top-up using Bluecol U Antifreeze to fill level as recommended by vehicle manufacturer (refer to handbook).
4. Replace Cap.

How do you calculate antifreeze ratio?

To find out how much you need to add, multiply the amount of coolant your vehicle can hold by the percentage of concentrated coolant you want to achieve. For example, if you want the coolant system to contain 50 percent of concentrated coolant, then you would multiply 0.50 x 12 to get an amount of 6 liters.

How many liters are in a gallon of antifreeze?

Amazon.com: Hella – G13 Coolant – 1 Gallon (3.78 Liters) – G013A8J1G : Automotive.

How do you measure the concentration of antifreeze in coolant?

Can you buy clear antifreeze?

clear antifreeze you need. EGW (Water and Ethylene Glycol) and PGW (Water and Propylene Glycol) are the two most common types of . clear antifreeze, both of which are available.

What is blue antifreeze?

Antifreeze Blue is a full concentrate which meets BS6580 and contains the same pure ethylene glycol and anti-corrosive additives as the Red. Its application is for protection for up to a maximum of 2 years.

What is the antifreeze water ratio?

The mixing ratio of water and antifreeze should lie between 60:40 and 50:50. This usually corresponds to antifreeze protection from -25°C to -40°C. The minimal mixing ratio should be 70:30 and the maximal 40:60. Further increasing the proportion of antifreeze (e.g. 30:70) does not lower the freezing point any further.

What strength should antifreeze be?

50/50
In most areas, a 50/50 solution is recommended for year-round use. If the weather turns extremely cold, you can add a slightly higher proportion of antifreeze without hurting your cooling system. Never exceed a 70/30 mixture of antifreeze to water.

What happens as the percentage of antifreeze in the coolant increases?

The beneficial effect of raising the boiling point ends with about 70-percent antifreeze. During the summer, engines will run warmer to hotter; therefore, as the percentage of antifreeze increases, heat transfer decreases because antifreeze has a lower specific heat than water.

Is it OK to use full strength antifreeze?

Using pure antifreeze inside your vehicle’s cooling system causes that system to lose about 35 percent of its ability to transfer heat versus a proper mixture of antifreeze and water. For this reason, you should not run your vehicle on pure antifreeze.