How can I charge my tablet if the port is broken?

How can I charge my tablet if the port is broken? 1. DIY USB port fix Turn off your device. If possible, remove the battery. Get a small stick to rearrange any misplaced tabs inside

How can I charge my tablet if the port is broken?

1. DIY USB port fix

  1. Turn off your device.
  2. If possible, remove the battery.
  3. Get a small stick to rearrange any misplaced tabs inside the USB port of your phone.
  4. If the charging pin is misaligned, lever it up slowly and gently.
  5. Reinsert the battery.
  6. Plug in the charger.

What to do if you have a damaged charging port?

Inspect both the cord and the connector. If you do see the damage, perhaps it’s time to buy a new Lightning Cable. If there is no visible damage, try using your computer as a charger by connecting your iPhone to your Lightning Cable, then plug in the cable to your computer’s USB port.

How do you replace the charging port on a HUDL 2?

Once open, disconnect the battery, remove (and later replace) the tiny bit of black tape over the old charging port, unplug the tiny speaker connector and unscrew the two little screws. Unplug the charging port, lift out and replace with this new one.

What happens if your tablet won’t charge?

Sometimes the problem of “my android tablet does not charge” is not with your tablet, it’s with your charging ports. Make sure that it’s bent or misshapen. Also you need to check your charger or your charging cable to get to know that the charging port is shaped correctly or not damaged.

How do I fix my HUDL 2?

2 Answers

  1. Switch off the tablet, by holding down the Power key for a short while.
  2. Press and hold the Volume Up button and the Power button, both together for a few seconds.
  3. Release the buttons when you see an Android Robot on the screen.
  4. To enter the Recovery Mode hold down the Power key for a short while.

How do you change the battery in a HUDL 2?

Step 3 Battery

  1. Unplug the old battery by gently rocking the white plug back and forth.
  2. Unscrew the four screws holding the battery down.
  3. Lift the battery out.
  4. Put in the new battery, reinsert the plug and replace the four screws.
  5. Test your tablet and make sure it’s working normally and will take charge.