What information can be found on your forklift data plate? Sometimes referred to as a capacity plate or a forklift nameplate, the forklift data plate includes important information such as weight, fuel type, and forklift
What information can be found on your forklift data plate?
Sometimes referred to as a capacity plate or a forklift nameplate, the forklift data plate includes important information such as weight, fuel type, and forklift load capacity. Associates need to read the data plate during training and before use to help build the culture of safety in your facility.
Where do you find the forklift specification plate?
The forklift data plate can be found on the instrument panel near the operating controls. It is the responsibility of the operator to understand the capabilities of each forklift and to properly maintain the data plate to ensure it is legible and complete.
What information on the forklift nameplate is most important to the operator?
load capacity
While the information on a nameplate can vary, the most important information is the load capacity. This tells you how much weight the forklift can safely handle without changing its center of gravity. The nameplate should include the weight of the forklift both with and without the battery.
What is a capacity plate on a forklift?
According to the Occupational Safety & Health Administration (OSHA), a standard forklift capacity plate is a nameplate that contains the capacity of the lift truck, where the capacity is defined as “the manufacturer’s guideline for how much weight a forklift can safely lift.”1 The nameplate contains a host of …
What is the center of gravity on a forklift?
An unloaded forklift’s center of gravity is between the axle of the steer wheels at A and the drive wheels at B-C. When the forklift is unloaded, the location of the center of gravity is the only factor for determining stability.
What is the data plate?
What is a Data Plate? The Data Plate is a paper label affixed inside the home and is the size of a standard sheet of paper (8 ½” x 11”). The Data Plate can be found in a kitchen cabinet, an electrical panel, or a bedroom closet.
How do you read forklift forks?
The main dimensions are:
- Carriage plate height (C) = Forks (tines) are mounted on a forklift carriage.
- Fork drop (D) = The fork drop is measure from the top of the lower hook to the floor.
- Length of fork (L) – measure from the end of the tip to the shank.
- Width (W) = width of the fork at its widest point.
When following another forklift it is best to keep behind?
The safe traveling distance between forklifts is approximately three truck lengths, or about a time-lapse of three seconds when passing the same point. More specifically, it’s about 20 feet between forklifts. The three-second rule is the same for automobiles on the road and is just as important for forklifts.
How far off the ground should forklift forks be?
6 to 10 inches
Keep the forks 6 to 10 inches above the ground to avoid potential hazards on the ground. Remember that forklifts are top-heavy. Carry the load low and tilted back. Use caution when carrying a load on an uneven surface; it creates a tip-over hazard.
What is the load Centre on a forklift?
The load centre represents the tipping point for a forklift truck. Essentially, a load centre is the middle of a forklift load, when measured front to back. This is calculated by measuring whatever it is you need to lift, then dividing by two (assuming an even load).
What are aircraft data plates?
Aircraft data plates contain all of the vital information about an aircraft. Typically made of metal, aircraft data plates are etched with registration information such as date of manufacture, model number, serial number, and registration number.