What is Rainbird error?

Charlotte SmithPopular tips

What is Rainbird error? When correctly displayed, the “MV ERR” message is part of the ESP Modular diagnostics function and identifies a short-circuit condition with the system’s master valve. What does alarm mean on Rainbird?

What is Rainbird error?

When correctly displayed, the “MV ERR” message is part of the ESP Modular diagnostics function and identifies a short-circuit condition with the system’s master valve.

What does alarm mean on Rainbird?

This is from the Rain Bird ESP manual: Possible Cause – A short circuit in the solenoid or valve wiring has disabled the station. ( ALARM LED on the faceplate is lit.) Solution – The display will show “# Err,” where # is the valve number at fault.

How do you clear a Rainbird alarm?

The status light on the module of the shorted station will blink continuously. Remove the shorted station wire from the module. In the Auto dial position select Alarm and Clear.

How do you reprogram a Rainbird?

How to Reprogram Rainbird

  1. Check the time and date on the controller to make sure it is accurate.
  2. Rotate the dial to the “Watering start time” position and press the “+” or “-” keys to reprogram the time of day the watering cycle begins.
  3. Turn the dial to the “Days to water” position.

Why is my Rainbird not working?

If the flush mode does not work, then simply turn off the water, disassemble, inspect and clean the valve. Make sure to clean all the small bleed ports underneath the solenoid and on the diaphragm’s surface. Replace your valve. You should also be sure to confirm that the diaphragm is not torn or damaged.

How do I know if my Rainbird solenoid is bad?

Signs You Have a Problem

  1. The Water Won’t Shut Off. If you have this problem, it’s very likely the solenoid.
  2. Low or Uneven Water Pressure. The solenoid controls the water pressure.
  3. Water Leaks. There are many points in a sprinkler system that can leak.
  4. Current Testing.
  5. Valve Inspection.
  6. Parts Replacement.

How do I know if my sprinkler system has a master valve?

It is connected to the “master” or “pump” connection in your controller. For Generation 1 controllers, this is the blue terminal in the wall mount. For Generation 2 controllers, find the terminal marked “M”. In the image below, the master valve is in the small circular box to the left of the main sprinkler box.

Why is my Rainbird sprinkler not working?

✻ dirt or debris in case or nozzle ✻ foreign lubricants ✻ excessive water pressure ✻ inadequate water pressure Page 6 4 RAIN BIRD Common Problems The sprinkler is stuck or won’t return – The most common reason for this is water pressure that is too high or to low.

https://www.youtube.com/watch?v=yZrPfBPXQx8