Will a Johnson lower unit fit a Evinrude?

Will a Johnson lower unit fit a Evinrude?

It is true that Johnson / Evinrude lower units can be interchanged however, you can’t rely on visual comparison alone.

How much does it cost to rebuild outboard lower unit?

A typical set of parts for the gearcase can cost $500-600 and may go higher if the gearcase is severely damaged. If you have your local mechanic repair the lower unit, his labor will run about $300-400 for this type of repair.

How often should you change lower unit oil?

every 100 hours
Most sterndrive and outboard manufacturers advise you to change the gearcase oil in your lower unit every 100 hours or once a year (whichever comes first). Clean oil is critical for protecting the heavily loaded gears in your lower unit and preventing expensive damage.

Are Evinrude and Johnson the same?

In 1936 the Evinrude company merged with the Johnson Motor Company to form the Outboard Marine Corporation. OMC declared chapter 11 bankruptcy in 2000 and its assets were subsequently acquired by Bombardier Recreational Products, which continued to build Evinrude branded outboard motors.

Are tohatsu and Mercury parts interchangeable?

So, if Tohatsu makes Merc, are the parts not interchangeable, is a merc shop not equally equipped to service a Tohatsu as it is a Merc if they are essentially the same motor.

How do you break in a lower unit?

Lower Unit & Sterndrive Break-in Procedure

1. Fill unit with manufacturer’s required gear oil to recommended level.
2. Adjust RPM at idle to manufacturer’s specifications.
3. Proper shift adjustment is essential.
4. Jumping out of gear: If the unit will not stay in gear, the clutch dog has probably been rounded off.

Can you use regular gear oil in a lower unit?

So, can you use any old gear lube in your marine lower unit? If you want the best protection possible, and want your lower unit to last as long as your boat, then the answer is no. Consult your engine’s manual and look for the proper marine gear lube for your application.