What is water equivalent thickness? In some situations, it is convenient to specify the water equivalent ratio (WER), which is the ratio of WET to material thickness, because WER values are approximately constant for some
What is water equivalent thickness?
In some situations, it is convenient to specify the water equivalent ratio (WER), which is the ratio of WET to material thickness, because WER values are approximately constant for some target thicknesses and beam energies and easier for comparison of results under different measurement or calculation conditions.
How do you calculate equivalent thickness?
Ieq = Ixx + I_cls = 2252 cm4/m. Paratie Plus calculates an equivalent thickness considering a rectangular section having an equivalent inertia. Finally: Ieq = I_cls + I_ipe Continue as the examples above.
What is equivalent thickness?
Equivalent thickness is essentially the solid thickness that would be obtained if the volume of concrete contained in a hollow unit were recast without core holes (see Figure 1).
What is the equivalent of water?
A substance’s water equivalent is equivalent to the amount of water that is required to consume the same quantity of heat as that substance does for a temperature rise of one degree. The water equivalent of a body is indeed equivalent to the product of its mass and its specific heat.
How thick is a 1 hour fire rated wall?
The most common fire rated drywall is known as type X, which is 5/8 inches thick, placed on each side of 2 by 4 or 2 by 6 inch wood studs and has a minimum fire rating of 1 hour.
What is water equivalent bomb?
In a specific reaction the quantity of heat that raises the temperature of some substance by some amount, the same quantity of heat can simultaneously raise the same temperature of a certain mass of water assuming the specific heat of water to be 1 calorie per gram. The mass of water is then termed as water equivalent.
Why do we calculate water equivalent?
Water equivalence value provides a clear picture about the heat absorbed by the calorimeter (in this case thermos flask is used as a calorimeter). Calculating water equivalence value is very important for calculating the heat of neutralization values.
How thick is a 2-hour fire-rated wall?
A 2-hour rating can be achieved by a wall with an equivalent thickness of as little as 3 1/5 inches when expanded slag or pumice is used or 4 1/2 inches when siliceous gravel is used as the aggregate. For cored units, the equivalent wall thickness is calculated by multiplying the percent solid by the wall thickness.