Why is my gas fireplace not igniting?

Why is my gas fireplace not igniting?

Another common issue with ignition is a dirty pilot light orifice, caused by a buildup of soot and dirt. If you have successfully re-lit your pilot light, ensured that the orifice is clean, and the fireplace still refuses to ignite, there could be an issue with the thermopile, thermocouple or wiring.

How do you reset the pilot light on a gas fireplace?

Hold the gas control button down while you hold the end of a lighted match or lighter at the end of the pilot tube. If you do this correctly, the pilot light should start as soon as the flame is close enough. Hold the pilot button down for about 20 seconds to give the thermocouple time to heat up, then release it.

Can you manually light a gas fireplace with electronic ignition?

It’s easy to know how to turn on a gas fireplace with an electronic ignition wall switch. Many gas fireplaces come equipped with a wall switch control panel for activating the unit and adjusting the level of the flame. Simply push the “On” button and the pilot should ignite.

What do you do when your gas fireplace won’t turn off?

Usually there is a rocker switch that is located around your burner which, if in the “ON” position, it will override the remote. Turn the switch to “OFF.” There may be a wall switch that allows you to turn your burner on. Turn the switch to “OFF.”

How do I restart my gas fireplace?

How to Start a Gas Fireplace with a Key

1. Step 1: Remove the outer cover of the fireplace to access the burner.
2. Step 2: Locate the metal keyhole near the fireplace.
3. Step 3: Insert the end of the key into the keyhole until it locks in place.
4. Step 4: Ignite a long lighter and place it next to the pilot burner.

Should pilot light always be on fireplace?

Should the pilot light always be on in a gas fireplace? Most gas fireplaces rely on a “continuous pilot light,” a type of pilot that remains lit so long as gas is flowing to the unit. If you have a continuous pilot light system, you should always see a pilot flame unless you have manually turned the system off.

How do you bypass a gas fireplace remote?

1. Usually there is a rocker switch that is located around your burner which, if in the “ON” position, it will override the remote. Turn the switch to “OFF.”
2. There may be a wall switch that allows you to turn your burner on. Turn the switch to “OFF.”
3. A slide switch on the receiver has been moved to the “ON” position.

What to do if pilot light on gas fireplace is not working?

Note: you MUST make sure the gas is off and there are no flames present prior to using an aerosol duster. Spray air around and into the end of the pilot tube opening and at the small air intake on the side of the pilot tube. If the pilot still fails, contact a qualified service technician to repair the gas log.

What should I do if my fireplace is not lit?

Without any gas, your fireplace won’t be able to light. Check the main gas valve to see if the gas is fully operational. If the gas is on and the pilot hasn’t been lit in a couple months, you might need to purge the air out of the pilot tubing.

Why does my gas fireplace light keep going out?

Another potential issue that can keep your gas fireplace from staying lit is that the thermopile may have gone bad. If the pilot light starts to flicker and looks like it may light but then simply burns out, the thermopile is usually the problem.

What to do if your fireplace is on the Fritz?

Here are some steps to take if your gas fireplace is on the fritz. Double check that the gas is actually on if your gas fireplace isn’t working correctly. Without any gas, your fireplace won’t be able to light. Check the main gas valve to see if the gas is fully operational.